Friday, December 21, 2012

3D Model of USB Tester OLED Adapter

Before I head out for a holiday break, I wanted to post a teaser of the USB Tester OLED Adapter. I ordered a few PCBs for the first prototype. I was able to breakout all of the unused pins on the Atmega32u4. There are a few that have a via close to the pin instead of a normal header on the edge of the board. I used eagleUp to create the 3D model. You can find it here if you would like to try it: http://eagleup.wordpress.com/. The model is only the PCB, I haven't had a chance to get the parts working yet.

Happy Holidays! Enjoy!





3 comments:

  1. What two colors are you using for the OSH Park boards with EagleUp?

    ReplyDelete
    Replies
    1. I got the colors from this site.
      www.color-hex.com
      When I get to a pic I can double check which exactly.

      Delete
  2. I got good results using traces: 0x5528b2 PCB: 0x33186a

    ReplyDelete